Low-Profile Hatroi HA221 Wire Routing Clips for 4-Cycle Engines  [HA221]

HATORI #221 WIRE HOLDERS FOR 4-CYCLE
Price:
NZD$6.63
Brand:
Hatroi
Model:
HA221
GTIN:
4538036002218
Condition:
Brand New
Write a review

Low-profile routing clips for 4-cycle engines

Hatroi HA221 clips offer a discreet way to route ignition leads and accessory wiring on 4-cycle RC engines, reducing the risk of wires catching on nearby parts. Their slim profile keeps wiring out of the way while preserving space in scale engine bays.

The holders work with single wires or small bundles typical of scale 4-cycle installations. Installation is quick: align the clip along the desired run, press the cable into the clip, and then re-check the layout after a short run to confirm secure routing.

When carrying out tuning or routine service, the HA221 helps preserve consistent wire paths so sensors and ignition leads stay clear of moving components and abrasion zones. Use several clips to maintain a tidy layout and simplify diagnostics.

Can these handle bundled leads as well as single wires?

Yes. The HA221 accepts single conductors and small grouped runs commonly used for ignition and accessory wiring in scale 4-cycle setups.

Are the clips a permanent fix or removable for rework?

The snap-fit design allows repositioning when needed, so you can move or replace clips during maintenance or when changing wiring routes.

Will these interfere with sensors or aftermarket wiring?

They are neutral routing aids; place them to keep sensor leads clear of heat sources and moving parts, and check routing compatibility before finalising sensor installations.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved