Tamiya 54786 Aluminium Front Mount 4 Degree for M-07  [54786]

Tamiya 54786 - M-07 Concept Aluminum Front Suspension Mount (4 Degree) OP-1786
Price:
NZD$23.06
Brand:
Tamiya
Model:
54786
GTIN:
4950344547869
Condition:
Brand New
Write a review

Upgrade your M-07 Concept with the Tamiya 54786 aluminium part

The Tamiya 54786 Aluminum Front Suspension Mount is manufactured from solid aluminium for greater stiffness compared with plastic originals, improving consistency and steering precision lap after lap.

Caster adjustment targeted at technical tracks

By changing the caster to 4 degrees rather than the B1 5 degree piece, this mount increases front grip during turn-in, which benefits short, twisty circuits and precise driving lines.

Robust anodised styling

The blue anodised surface offers a race-ready appearance while protecting the alloy. The Tamiya 54786 is built to withstand frequent use at club sessions and practice runs.

Simple installation for M-07 chassis

This mount is made to fit the M-07 Concept chassis without modification, allowing a straightforward replacement of the stock front mount to refine handling characteristics.

Will this change make the car oversteer more?

The 4 degree caster tends to increase front bite and improve turn-in, which can reduce understeer; proper setup of rear traction and damping will balance the chassis.

Is any trimming or drilling required to fit?

No trimming is normally needed. The mount is designed for direct fitment to M-07 Concept layout and uses existing fasteners and locations.

Can I use this on damp or dusty surfaces?

Yes, the aluminium body handles a range of conditions; keep pivot areas clean and lubricated to maintain smooth steering operation in wet or dusty environments.

Does the Tamiya 54786 change steering geometry beyond caster?

The primary change is the caster angle. Other geometry remains the same, so you can tune toe, camber and damping independently after installation.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved