TRAXXAS MAXX Adjustable CVD Half Shaft Upgrade TXMS143FRS by GPM  [TXMS143FRS]

Heavy-duty CVD half shaft kit for TRAXXAS MAXX

This 34 piece aftermarket kit is made as a replacement driveline for TRAXXAS MAXX monster trucks, aimed at improving strength and offering setup flexibility. Torque is carried through CVD swing joints into reinforced axles, combining hardened steel contact points with 6061-T6 aluminium housings to control flex and weight.

The set swaps out cross-pin half shafts for adjustable CVD assemblies and supplies hardware to suit the increased 8mm axle diameter, along with bearings and fasteners required for retrofit. Adjustable tie rods let you change track width and fine-tune steering geometry when paired with widening kits.

Install the TXMS143FRS kit to beef up front and rear drivelines on widened TRAXXAS MAXX rigs; it is intended to improve torque delivery and make servicing easier while keeping chassis changes minimal.