Medius X26 1.4mm Sway Bar Upgrade - Serpent 402196 (compatible with Medius X26 steel EP SER400052)  [SER402196]

Overview of the 1.4mm Sway Bar for Medius X26

The Serpent 402196 antiroll bar serves as a suspension tuning part for the Medius X26 steel EP platform (SER400052). Choosing the 1.4mm section delivers a clear increase in lateral stiffness to control body roll while leaving spring and damper tuning intact.

Fitting is performed at the chassis: the bar connects to the linkage points laid out by the Medius X26 design. Confirm that all link joints are free-moving and that end links do not bind throughout suspension travel. Correct alignment helps retain consistent roll behaviour and suspension geometry.

From a setup perspective, stepping up to a 1.4mm bar concentrates handling changes on transient roll and corner entry balance compared with lighter bars. Use measured, incremental changes and test on-track to assess the net effect on handling.

Steel bars are low maintenance: check for play at connection points and inspect surfaces after hard runs. Re-torque mounting bolts as recommended and replace the bar if bends or heavy wear appear.

Fit the Serpent 402196 antiroll bar to hone roll balance on Medius X26 steel EP machines, pairing it with stepwise suspension changes for repeatable handling.