Medius X26 Front Body Support, Graphite - O-SPP008 for Serpent by Factory Pro  [FP-O-SPP008]

Price:
NZD$15.02
Brand:
Factory Pro
Model:
FP-O-SPP008
Condition:
Brand New
Write a review

Medius X26 Front Support Overview

The Factory Pro O-SPP008 front body support is a graphite replacement made for the Serpent Medius X26 platform. It serves as an alignment aid for the front of the body shell and is not intended to modify primary suspension or drivetrain performance.

Matched to the Medius X26 layout, the support creates a repeatable mounting datum for the nose section so you can refine body position and shell fit quickly during setup checks. Graphite offers stable dimensions while keeping weight addition minimal, suitable for precise chassis tuning.

Fitting is simple for those familiar with Medius X26 maintenance: remove the original front support and secure the O-SPP008 to the same chassis points. Keep mounting geometry square and use consistent fastener torque to ensure repeatable body indexing.

What steps are involved in fitting this part?

Remove the existing front support, align the O-SPP008 with the chassis attachment points, and secure using the original hardware. Verify clearance and body alignment before final tightening.

Do I need special hardware to install it?

The support is designed to use the Medius X26's standard mounting hardware in most cases. If different fasteners are required, match thread size and length to the chassis specifications.

Recommended torque or alignment checks?

Tighten fasteners to the chassis maker's recommended torque and confirm the body shell sits square and centered. Small adjustments to mounting points can fine-tune nose height and gap consistency.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved