Medius X26 Graphite Main Chassis 2.25mm - O-SPP001 for Serpent by Factory Pro  [FP-O-SPP001]

Price:
NZD$78.35
Brand:
Factory Pro
Model:
FP-O-SPP001
Condition:
Brand New
Write a review

Graphite chassis plate built for Medius X26

This Factory Pro main chassis replaces the stock main plate on Serpent Medius X26 1/10 touring cars and is specified at graphite 2.25mm thickness. It is offered as an aftermarket replacement aimed at altering chassis rigidity and influencing handling characteristics for varied driving conditions.

The design targets direct swap compatibility with Medius X26 mounting points. Before fitting, check that your standoffs and electronic components align with the graphite plate profile and that there is adequate clearance for the ESC, motor, and servo. The chosen material and thickness change flex behavior so racers can tune handling without changing suspension geometry.

After installing, perform routine inspections for delamination or edge impact, verify fastener torque, and ensure there is no contact with electronics. Graphite provides a rigid, lightweight alternative to composite plates and may require modest suspension or anti-roll adjustments to restore balance.

Specifications

  • Item: Main chassis
  • Material: Graphite 2.25
  • Model Number: O-SPP001
  • Compatibility: Serpent Medius X26

Compatibility

  • Serpent Medius X26

Fit this plate when you need a simple, durable way to alter chassis stiffness on a Medius X26, then fine tune suspension settings to assess lap time and consistency gains.

Does this plate improve resistance to edge damage?

Graphite is rigid and wear resistant, but impacts can still chip edges. Regular visual checks will catch damage early so you can replace the plate if cracks appear.

Can the 2.25mm thickness survive heavier track abuse?

The greater thickness increases structural stiffness and offers improved handling under load, though extreme impacts may still harm the plate. Inspect after crashes.

What maintenance is recommended for graphite plates?

Clean grit from surfaces, retorque fasteners after initial runs, and check edges and mounting holes for signs of wear or widening. Replace if structural cracking is present.

Will the plate shift electronics height?

The 2.25mm thickness can alter component stacking slightly. Confirm ESC and servo clearances and adjust mounting positions if needed to avoid interference.

Is this suitable for competition and practice?

Yes. It works for both applications; use it to explore chassis stiffness levels and then refine suspension tune for consistent lap times.

Are mounting screws included in the sale?

The item is the main chassis plate only. Confirm whether your current fasteners are compatible or need replacing when fitting the new plate.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved