Medius X26 (SER400052) Front Left and Right Steering Mounts for Serpent 402177  [SER402177]

Fitting guide for X26 front mounts

The Serpent 402177 steering block mount pair provides the left and right front mounting points used on Serpent Medius X26 kits identified by SER400052. These RC-scale spare parts are produced to match the X26 front steering assembly for maintenance, repair, or setup changes on 1/10 electric touring car chassis.

Forged/machined in steel to resist wear, the components act as the connection between steering knuckles and the tie rods, influencing toe and steering feedback. When replacing original items, make sure each piece is fitted to the correct side and that any reused hardware matches thread pitch and length.

Installation notes: place the correct side component on its wheel hub, start bolts by hand to check alignment, then torque to the hub and steering arm per your chassis guide or previously recorded settings. Once installed, move the steering through its range to confirm no interference and then recheck alignment at rest.

Tuning impact: these mounts are structural elements of front steering geometry; differences in material stiffness or offset will change steering feel. Use them to lock in toe settings or when upgrading to harder components to limit flex during heavy cornering.