Medius X26 Sway Bar 1.2 X26 for Medius X26 steel EP - Serpent 402194  [SER402194]

Sway bar overview and application

The Serpent SER402194 is supplied as an RC antiroll bar, marked 1.2 X26 and recommended for the Medius X26 steel EP kit (SER400052). It is a direct-fit style sway bar built to influence lateral stiffness across the chassis on electric scale cars.

The 1.2 X26 label identifies the diameter and length profile, which correlates with stiffness relative to alternate bars. When adjusting setups, swapping this bar will change how the chassis transfers load side-to-side during turns; make one change at a time and record the effects.

Fitting is typical for kit sway bars: locate the bar in the chassis mounts and connect it to the suspension linkages, replacing the factory item where applicable. Verify mount alignment and linkage geometry before final clamping, and confirm the bar travels freely through the suspension’s full range. Inspect steel components routinely for wear and tightening after running sessions.

Use this antiroll bar as a discrete tuning step to refine roll-stiffness balance on the Medius X26 steel EP chassis.