MF01X Rear Suspension Aluminium Arm MF056 by GPM  [MF056]

Rear aluminium suspension arm for MF01X setups

This aluminium rear suspension arm is offered as an aftermarket replacement for MF01X platforms, supplied as a 1pr set for scale RC applications. The component emphasises increased stiffness and improved service life over standard moulded arms, aimed at hobby tuners working on MF01X and M06 chassis.

Fitment and role: intended for MF01X and M06 layouts, the arm serves as the rear lower control link and influences roll centre, camber tendencies and suspension geometry under load. Compared to flexible plastic parts, aluminium arms keep linkage geometry more consistent, which helps when adjusting shock length, anti-roll behaviour or caster settings for stable cornering.

Installation notes: designed to use the vehicle's original rear suspension mounting points; confirm compatibility with your chassis and fasteners before final assembly. Check thread condition and pivot interfaces during fitting and ensure bearings or bushings are serviceable where the arm meets the hub carrier.

Fit this arm if you want a stiffer rear link for repeatable tuning results, but allow for setup tweaks since aluminium will change the feel compared to stock pieces.