Midshaft Pully 20T X26 for Medius X26 steel EP SER402197 Serpent  [SER402197]

Overview of the 20T X26 midshaft pully for Medius X26

This midshaft pully serves as an RC drivetrain component designed specifically for the Serpent Medius X26 steel EP kit (SER400052). It works as the midshaft gear element that transmits rotation through the mid-engine drivetrain and is produced in a 20-tooth X26 profile to fit Medius X26 geometry.

The focus for this replacement part is on maintaining correct tooth geometry and dependable drivetrain behavior rather than aesthetics. In real use it influences gear alignment, torque handoff between the midshaft and adjacent gears, and the way the drivetrain reacts under load. When fitting or tuning the pully, ensure tooth profile alignment and clearance to the spur and idlers to avoid accelerated wear.

Installation recommendations: clean and inspect the mating bore and keyways for burrs, check for runout and axial movement after assembly, and use the kit-specified hardware torque values. Perform early run inspections to confirm stable mesh and bearing loading.

As a direct-fit replacement, this Serpent pully for the Medius X26 steel EP emphasizes accurate tooth form and sturdy steel construction to support consistent drivetrain tuning and longevity.