Mini 4WD Rail Guard M4WD-49/RE Aluminium Red - Upgrade by 3Racing  [M4WD-49/RE]

Red aluminium rail guard M4WD-49/RE for Mini 4WD setups

The 3Racing M4WD-49/RE is supplied as an aluminium rail guard intended for Mini 4WD vehicles as an aftermarket styling and stiffening part. Its machined red finish gives a consistent metal aesthetic for hobbyists matching multiple aluminium accessories.

This single-piece guard is machined from aluminium. The notes below address material benefits, anticipated fit around standard Mini 4WD rail geometries, and what to expect visually. Because hole spacing and clearances can vary between chassis makers, measure your mounts before committing to fitment.

For builders the guard serves mainly as a cosmetic and structural upgrade: it rigidifies the rail area in comparison to factory plastic guards and presents a uniform red metal look. Check interactions with rollers, stabilisers and mounting brackets; modest spacing changes or washers typically correct small fit issues.

Installation advice is intentionally general; check the product listing for included screws or spacers. If none are supplied, standard small machine screws common to Mini 4WD accessories will usually work. Tighten fasteners carefully to prevent deformation of thin aluminium sections.