Mini Inferno 09 45mm Front Half Shaft MIF1245 by GPM  [MIF1245]

45mm alloy front axle shaft for Mini Inferno

This 45mm alloy front dog bone is a replacement half-shaft suitable for Kyosho Mini Inferno and Mini Inferno 09 models, sold as model MIF1245. It transfers torque from the centre differential to the front hubs and is intended for stock or lightly tuned vehicles.

Choose the alloy option when replacing brittle or worn plastic shafts to keep front drivetrain engagement consistent. The forged alloy provides a compromise of stiffness and wear resistance over common molded parts, and the 45mm length retains original fitment for the named Mini Inferno variants.

Fitment notes: check axle retainers and C-clips for signs of wear prior to installation, verify the 45mm measurement against your hubs, use thread locker only where the chassis manual recommends, and confirm free rotation through suspension travel after assembly. Typical hobby hand tools are sufficient.

Performance note: installing alloy dog bones can tighten up the front driveline and yield a more repeatable steering response under throttle. Expect incremental improvements in traction behaviour; start with differential and suspension tweaks for larger handling changes.