Mini Spyder SER440001 Chassis Countersunk Allen Screw M2x16 - Serpent 110256  [SER110256]

Serpent SER110256 Screw allen countersunk m2x16
Price:
NZD$10.43
Brand:
Serpent
Model:
SER110256
Condition:
Brand New
Write a review

M2x16 replacement countersunk fastener

This M2x16 allen countersunk screw serves as an RC replacement fastener listed as Serpent SER110256 and is intended for the Mini Spyder Monster truck RTR EP (SER440001) chassis. The countersunk head allows the screw to sit flush with panels and suspension mounts, reducing snagging and interference.

Keep this part on hand for routine service or to replace screws lost in hard landings. The allen drive combined with the countersunk form factor is common for chassis attachment points where a low-profile finish is needed.

Installation guidance: feed the screw into the countersunk bore until the head is level with the surface, tighten evenly to prevent cross-threading, and inspect mating threads before reinstalling. When doing repairs, match screw lengths to preserve stack height and clearance.

Is SER110256 the correct spare for the Mini Spyder (SER440001)?

Yes. The part is listed as Serpent SER110256 specifically for the Mini Spyder Monster truck RTR EP (SER440001) chassis and is intended as a direct replacement.

Can I use this screw on other chassis points?

You can use it where an M2x16 countersunk fastener is specified and a flush finish is required, but confirm thread and length compatibility before swapping with other locations.

Any tips for replacing multiple screws at once?

Replace matching screws in pairs or sets to maintain even clearance and stack heights. Inspect all mating holes for wear and clean threads prior to fitting Serpent SER110256 screws.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved