Mini-T Rear Shock Tower Plate Graphite MT-014A by 3Racing  [MT-014A]

Graphite rear shock tower for Mini-T

The MT-014A graphite rear shock tower plate is an RC replacement part shaped to suit Team Losi Mini-T rear suspension arrangements. It serves as a direct replacement for the stock rear tower plate while keeping the factory mounting holes intact and providing a firmer mounting surface for the shocks.

Compatibility is limited to Team Losi Mini-T patterns as identified in the product name, and the plate is supplied as a single component intended to use existing hardware and shock mounting screws from the vehicle. No additional brackets or machining are required for standard Mini-T setups that use the factory hole pattern.

For setup and tuning, a graphite plate changes rear-end stiffness and pivot characteristics. A stiffer tower plate reduces local flex at the upper shock mounts, letting hobbyists refine rebound and compression through shock setup rather than chassis flex. Use the plate when experimenting with shock angle, spring rates or ride height to evaluate handling changes.

Fitment guidance: remove the OEM rear tower plate, align this replacement to the stock hole pattern and tighten using the same screws. Double-check shock alignment and body clearance after installation, then run a short test to confirm ride height and travel.