Mini-Z AWD Adjustable Toe Link -2 degree AWD-10/-2 by 3Racing  [AWD-10/-2]

Kyosho Mini-Z AWD Mini Z AWD Front Toe In / Out Linkage -2 Degree - 3RACING AWD-10/-2
Price:
NZD$6.51
Brand:
3Racing
Model:
AWD-10/-2
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Mini-Z AWD front toe adjuster -2 degree

This small-scale front toe in/out linkage is intended for Kyosho Mini-Z AWD MR-03 compatible cars and is identified as model AWD-10/-2. It changes front toe to a -2 degree setpoint and serves as a direct replacement or upgrade to the standard front linkage on MR-03 style AWD layouts.

Fitting is straightforward: remove the existing linkage and secure the new unit to the factory mounting points. Confirm that the linkage ends move freely with the steering tie rods and that there is no binding throughout steering travel. Reuse the same basic fasteners where appropriate and use common hobby tools for a reliable fit.

Tuning notes: increasing negative toe gives crisper initial turn-in and can help on tight, technical tracks, but may loosen straight-line tracking. Make measured changes, test on the track you know, and log each setup so you can reverse any change if needed.

Is this compatible with MR-03 AWD cars?

Yes, the part is made for MR-03 style Mini-Z AWD chassis. Double-check that your car's linkage mounts match before proceeding.

Can I use the original screws?

In most cases the original fasteners fit; inspect thread sizes and replace any worn hardware. Torque to a secure setting without introducing steering bind.

When should I switch to -2 degree toe?

Try -2 degree when you need faster turn-in on short or tight courses. Make small changes and evaluate lap times and driver confidence to confirm improvement.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved