Mini-Z AWD Alloy Rear Knuckle Arm Plate 0.6mm, 0.2mm Toe - MZA031R+0206 by GPM  [MZA031R+0206]

Rigid rear knuckle plate for Mini-Z AWD

This alloy rear knuckle arm holder is an upgrade sized for Kyosho Mini-Z AWD use, designed to secure the rear hub and maintain a 0.2mm toe-in. The thicker 0.6mm alloy helps reduce flex compared with thin stamped parts, preserving rear alignment through setup changes and play sessions.

Choose this part when you need a consistent toe setting and a tougher knuckle mount for Mini-Z AWD models. It accepts standard Mini-Z knuckle hardware and replaces softer original holders, delivering predictable alignment for precise tuning.

Mounting and tuning advice

• Check chassis compatibility before fitting and start fasteners by hand to avoid cross-threading.
• Note the 0.2mm toe-in is fixed by the plate; it is a set geometry solution rather than an adjustable item.
• Verify clearance with the motor and wiring after installation to prevent contact on AWD configurations.