Mini-Z AWD Rear Knuckle Arm Holder Alloy 1.0mm Toe 0.4mm MZA031R+0410 by GPM  [MZA031R+0410]

Lightweight alloy rear knuckle holder for Mini-Z AWD

This aftermarket alloy rear knuckle arm holder is supplied as a single unit for Kyosho Mini-Z AWD cars and is made to provide a firmer alternative to stock plastic carriers. The plate measures 1.0mm thick and incorporates a 0.4mm toe-in offset for precise small-scale adjustments.

Role and compatibility: the holder secures the rear knuckle arm and establishes the rear axle toe on MR-03 AWD style Mini-Z chassis. Fit it to replace fatigued plastic parts or to experiment with small toe changes that affect cornering balance.

Fitting tips: remove the rear hub assembly following normal Mini-Z service procedures, fit this alloy carrier in place of the original, and reuse suitable screws and bearings where they match. After installation, check for free rotation and correct clearances. Extra fasteners are not included unless specified by the seller.