Mini-Z AWD Rear Knuckle Arm Holder Toe In +0.1mm MZA031R/+0.1 by GPM  [MZA031R/+0.1]

Rear toe adjustment holder for Mini-Z AWD

This aluminium alloy rear knuckle arm holder is an aftermarket replacement designed for Kyosho Mini-Z AWD cars and is supplied as 1 pc. The part applies a +0.1mm toe-in change so you can fine-tune rear geometry without altering hub spacing.

The holder positions the rear knuckle arm to produce the stated Toe In +0.1mm. When fitted to a Mini-Z AWD MR-03 chassis this modest offset helps refine turn-in and mid-corner behaviour for tighter track layouts.

Installation is simple for a modeller used to Mini-Z servicing: remove the stock plastic holder, fit the alloy item into the same mounts, and reuse the original hardware. Use the correct hex driver, avoid over-torquing, and verify alignment and clearances after fitting. Inspect nearby linkage and bearings during the swap.

Great for hobbyists wanting subtle handling tweaks with a durable alloy part.