Mini-Z AWD Rear Toe In/Out Linkage 3 Degree for Kyosho - AWD-09/3 by 3Racing  [AWD-09/3]

Rear toe linkage engineered for Mini-Z AWD tuning

This rear toe in/out linkage is built for the Kyosho Mini-Z AWD platform to replace the factory rear link and lock in a consistent 3 degree toe position. The part is supplied in purple and is aimed at hobbyists who do repeatable setup testing on Mini-Z AWD cars.

Functionally it sets a measured rear toe so handling comparisons are reliable across runs. Use the linkage when you want a known 3 degree rear baseline for sorting corner entry balance or comparing tyre and shock changes.

Installation notes: remove the original rear toe linkage on the Mini-Z AWD, move any necessary ball cups or spacers from the stock part, and attach the replacement using the existing hardware. Verify thread engagement and ensure the linkage rotates freely without binding prior to running the model.

Tuning tips: start from the stock geometry and then fit the 3 degree link, tweak in small increments while altering front toe or roll center, and test on the same surface for clear comparison. Minor toe shifts mainly affect turn-in and mid-corner rotation rather than straight-line stability.