This product is a pair of alloy rear rims supplied as 1 pr (2 pcs) for use on Mini-Z AWD micro cars. The wheel is described as a rear wide sinkage rim with 11mm width, 0mm offset and an 18p bolt pattern to accommodate wider tyre profiles and altered track width.
The rims are intended as an aftermarket tuning option compatible with Mini-Z AWD chassis. Before fitting, verify your hub and wheel hex interface to confirm secure seating and correct alignment.
Fitting advice: remove stock rear wheels and fit the new rims ensuring the hex seats fully into the hub, then secure with the correct 18p hardware or original nuts. After installation confirm tyre fitment and check body and suspension clearance at low speed. Wider rear rims change rear grip characteristics, so fine tune springs and sway settings as needed to regain handling balance.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
