Mini-Z AWD Rear Wide Ridge Delrin Wheels 6p 0mm Offset Width 8.3mm DMZA601RW888 by GPM  [DMZA601RW888]

Mini-z AWD Delrin Rear Wide Ridge Rims (6p, 0mm Off set , Width 8.3mm) With Tires - 1pr set - GPM DMZA601RW888
Price:
NZD$8.23
Brand:
GPM
Model:
DMZA601RW888
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Delrin rear wheel set for Mini-Z AWD tuning

This pair of scale wheels and tyres is intended for Mini-Z AWD cars, listed as model DMZA601RW888. Constructed from Delrin, the rims are labelled 6p with a 0mm offset and an 8.3mm wheel width, and they arrive pre-mounted with tyres ready for indoor track use.

Fit and installation: check the rear hub hex and wheel retention system on your Mini-Z AWD before installation, then swap out the stock rear wheels using the same fasteners. The 0mm offset and 8.3mm width should be checked for interference with bodyshell edges and rear suspension components on MR-03 AWD variants. Inspect wheel runout and torque the hex screws correctly.

Tuning notes: the wider rear rims alter tyre geometry and contact patch compared with standard wheels, which is useful for adjusting rear grip on carpet or indoor layouts. Delrin rims are dimensionally stable for predictable tyre mounting; select tyre types and inserts to fine tune balance.

Are these compatible with MR-03 AWD hubs?

They are meant for Mini-Z AWD platforms, but compatibility depends on your specific MR-03 AWD rear hex and hub. Measure the hex size and check fitment before use.

Do I need special hardware to mount them?

No special hardware is usually required; reuse your car's existing rear wheel screws and confirm they seat correctly into the rim hex.

Will tyre swaps affect handling?

Yes, swapping tyre compound or inserts changes grip and balance. After changing tyres, check balance and consider small trim adjustments to the car's setup.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved