Mini-Z MR-02 Motor Mount Upgrade with Graphite Top - KZ-06/V2/WO by 3Racing  [KZ-06/V2/WO]

Kyosho Mini-Z MR-015 AL Motor Mount W/ Graphite Plate Ver. 2 For Mini-Z MR-02 RM - 3Racing KZ-06/V2/WO
Price:
NZD$21.42
Brand:
3Racing
Model:
KZ-06/V2/WO
Condition:
Brand New
Write a review

Aluminum base motor mount with graphite top for the MR-02 RM

The KZ-06/V2/WO is a direct replacement motor mount for Kyosho Mini-Z MR-02 RM chassis, combining a rigid aluminum base with a graphite top plate to reduce the flex that can affect stock plastic mounts.

Setup and tuning role: the aluminum section locks motor seating while the graphite plate controls flex between the motor assembly and chassis trays, promoting repeatable gear alignment and a more consistent drive feel when tuning for marshalling or race layouts.

Installation advice: remove the existing motor mount following standard chassis disassembly, install the upgrade and confirm correct pinion-to-spur mesh. Make sure the motor wiring clears the graphite plate before powering up.

Is any trimming required to fit this mount?

No trimming should be necessary for MR-02 RM chassis; the part is designed as a direct-fit replacement for the stock mount.

Will this change gear wear?

By stabilizing motor alignment the mount can help keep gear mesh consistent, which may reduce irregular wear from misalignment under load.

Any recommended checks after fitting?

After fitting, confirm motor mesh at several shaft positions, secure fasteners to spec, and verify there is no rubbing between wiring and the graphite plate.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved