Mini-Z MR02-LM 0 Degree Steering Block Aluminium KZ-15/0/GO by 3Racing  [KZ-15/0/GO]

Kyosho Mini-Z MR-015 Aluminium Steering Block (0 Degree) For Mini-Z MR02-LM - 3Racing KZ-15/0/GO
Price:
NZD$17.14
Brand:
3Racing
Model:
KZ-15/0/GO
Condition:
Brand New
Write a review

MR02-LM 0 degree aluminium steering knuckle

The KZ-15/0/GO steering block is an aluminium upgrade made for the KYOSHO Mini-Z MR02-LM chassis, offered at a 0 degree specification. It replaces the stock plastic knuckle with a metal item for improved consistency during setup sessions.

Zero degree indicates the block does not introduce extra steering angle compared with the factory geometry, making it useful when you need a neutral reference for tuning or comparing different steering parts.

Installation uses the MR02-LM steering mounting points; no cutting or chassis modification is required. Confirm fitment to your steering assembly and use suitable small hex drivers to avoid rounding fasteners.

As part of tuning, fitting an aluminium steering block is a conservative change that pairs well with tie rod adjustments and tyre selection to assess handling across different surfaces.

Is the KZ-15/0/GO compatible with MR02-LM?

Yes, the part is designed for the MR02-LM pattern. Double-check your vehicle's knuckle layout before fitting to ensure correct alignment.

Will changing to aluminium change steering feel?

Aluminium can make the steering feel firmer and more consistent; combine this swap with small steering link or trim changes to dial in balance.

Do I need to shim or adapt anything when fitting?

In most cases no extra shims are needed. Fit the block, check for binding across the steering travel, and add thin shims only if you see contact or misalignment.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved