MP10 Side Guard IF614B for Kyosho - Reduced-Height Lightweight  [KY-IF614B]

Kyosho IF614B - Side Guard (MP10)
Price:
NZD$24.53
Brand:
Kyosho
Model:
KY-IF614B
GTIN:
4548565470129
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $19.88 each $9.29 or 19%
3+ $18.89 each $16.92 or 23%
Write a review

Compact side guard tailored to MP10

This replacement side guard is crafted for the Kyosho MP10 chassis. The revised contour reduces both thickness and overall height to shave about 18g versus the factory unit while tapering toward the rear to clear the body and remove surplus material.

Functionally the part keeps the chassis profile intact while cutting mass and lowering the risk of shell interference. From a setup perspective it offers a small drop in weight along the chassis flank and helps maintain steady clearance between the body and suspension movement, assisting in balanced handling on paved tracks.

Installation uses the MP10 side guard mounting holes and existing hardware; position the guard against the chassis flange, secure fasteners progressively, and do not overtighten to avoid distortion. Check the shell fit after securing and make fine alignment tweaks if necessary.

Compatibility

  • MP10
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What is the expected mass reduction with the IF614B?

The update delivers around an 18 gram saving compared to the original side guard design.

Will my existing MP10 screws work with this piece?

Yes, it is designed for direct installation using the MP10 mounting points and the hardware already on the chassis.

Does the new shape affect shell trimming?

The narrowed rear section improves clearance, which typically reduces the need for additional shell trimming during suspension travel.

Any recommended fitment steps?

Mount the guard in place, tighten each screw a little at a time to even out stress, then test the body fit before final tightening to prevent misalignment.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved