MR-04 Roll Damper Upgrade for Mini-Z (MR-04/MZW714-LM/MM) - Kyosho MZW715  [KY-MZW715]

Overview: MR-04 roll damping

The Kyosho MZW715 roll damper set is a purpose-built replacement hop-up for Mini-Z MR-04 platforms, specified for MR-04/MZW714-LM/MM fitment. It concentrates on managing roll dynamics so racers can dial in chassis behaviour while leaving suspension geometry intact.

Compatibility notes: the component is limited to the listed MR-04 variants and should be used only on MR-04 based chassis to ensure correct alignment and clearance. As a tuning component it modifies roll reaction during cornering to enable more predictable handling.

Fitting summary: take out the original rear roll parts from the MR-04 rear assembly, install the MZW715 items following the chassis service instructions, then confirm clearances and torque values. Typical RC hand tools such as a hex driver and small pliers are adequate.

Tuning guidance: use the MZW715 to control the rate at which the model rolls into and recovers from turns. Begin with small adjustments, run short evaluation laps, and progress stepwise to find the best compromise between mid-corner stability and drive out of the corner. Match damper settings with tyre choice and ride height for consistent results.