Mr. Hobby GSI-GT33 Spout Kit for Mr. Thinner 250ml & 400ml  [GSI-GT33]

Mr.Hobby GSI-GT33 - Spout Set For Mr Thinner 250&400ml
Price:
NZD$7.94
Brand:
Mr.Hobby
Model:
GSI-GT33
GTIN:
4973028135190
Condition:
Brand New
Write a review

Smart Pouring Aid for Thinner Bottles

Model makers who regularly mix paints will find the Mr. Hobby GSI-GT33 spout set useful for everyday thinning chores. Built for the 250ml and 400ml Mr. Thinner bottles, it helps reduce spills and waste during small mixing sessions.

Stable Flow for Precise Mixing

The spout is shaped to provide a controlled stream from Mr. Thinner containers, making it easier to measure and combine thinner with paints. That steadier flow is especially handy for fine detail spraying and brush work.

Simple to Fit, Easy to Keep Clean

This GSI-GT33 accessory attaches quickly to both the 250ml and 400ml Mr. Thinner bottles and stays put during use. Easy cleaning and installation mean less downtime on the workbench.

Can the spout be used with solvent jars?

The design is optimised for Mr. Thinner bottle threads and may not seal on generic solvent jars, so check fit before relying on it.

What is the best way to clear a blocked spout?

Flush the spout with a little thinner or warm soapy water depending on the solvent used, then dry thoroughly to prevent residue build up.

Does the spout affect pour speed?

The spout moderates flow to give a smoother, slower pour than an open bottle, which helps with precise measurements.

Should I store the spout on the bottle?

You can leave it fitted between sessions, but if you store for long periods cap the bottle or remove and clean the spout to avoid crusting.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved