MS Super-II MA Mini 4WD Carbon Plate Reinforcement M4WD-09_SG by 3Racing  [M4WD-09_SG]

Tamiya Mini 4WD Carbon Reinforcing Plate Set - 3RACING M4WD-09_SG
Price:
NZD$8.57
Brand:
3Racing
Model:
M4WD-09_SG
Condition:
Brand New
Write a review

M4WD-09_SG carbon reinforcing plate set for tuned Mini 4WDs

This carbon plate kit is offered as an upgrade accessory for Mini 4WD hobbyists. The single-piece panels provide targeted rigidity where builders want a flat, lightweight reinforcement without modifying drive layout or recommending motor swaps. The description concentrates on materials and fit.

Confirm compatibility by aligning the mounting holes with popular performance chassis like Super-II, MA, MS, AR, FM-A and VS. These plates are intended to trim down unwanted flex in the chassis stack and may need modest trimming or relocated screws on certain versions to achieve a perfect fit.

Collectors can use the plates as OEM-style spares or as replacements for damaged parts. Installers should pay attention to spacer choices, screw lengths and clearance to rollers and gears to preserve smooth operation. This overview keeps installation advice practical rather than prescriptive.

How do I check if the plate will fit my chassis?

Lay the plate over your chassis and inspect hole alignment; common fits include Super-II, MA and MS, but small adjustments are often needed.

Is the plate load bearing during impacts?

The plates increase stiffness and can help with minor impacts, but they are not a substitute for crash protection or reinforced bumpers.

Will fitting require trimming or extra hardware?

Some chassis need light trimming or different spacer arrangements; verify screw lengths to avoid contacting moving parts before final tightening.

Can this be used on show cars as an original spare?

Yes, many collectors keep carbon plates as period-appropriate spares or use them to restore structural integrity to older cars.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved