MTX-4 52T Delrin Spur Gear Replacement MTX4-0852/V2 by 3Racing  [MTX4-0852/V2]

Mugen Seiki MTX4 Low Friction Delrin Supr Gear 0.8 Pitch 52T Version 2 - 3RACING MTX4-0852/V2
Price:
NZD$3.94
Brand:
3Racing
Model:
MTX4-0852/V2
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Delrin Spur Gear 52T for MTX-4

Supplied as Version 2, this 0.8 pitch, 52-tooth Delrin spur gear is made for MTX-4 scale RC drivetrains. The Delrin construction offers a low-friction, wear-resistant alternative to some composite spur gears, helping to reduce drivetrain drag.

Use this unit when a direct swap with the MTX-4 spur is required on compatible gearboxes. During installation, check the mesh with the motor pinion to avoid binding, clear any molding flash, and confirm free rotation of the gearbox before full-power testing. This is a scale RC accessory and not intended for full-size applications.

As a Version 2 item, install following the same alignment and fastening practices used for original MTX-4 spur gear replacements, ensuring gearbox cover and retainers are correctly secured.

Is the gear a direct swap for MTX-4?

Yes, it is intended as a direct-replacement spur gear for MTX-4 compatible gearboxes.

Will this change gear ratio?

No, the 52-tooth, 0.8 pitch specification keeps the same gear ratio as the original 52T spur on MTX-4 setups.

Any tips for secure fastening?

Tighten gearbox cover or retainer screws to the recommended torque, confirm alignment, and recheck mesh after final tightening to avoid post-install binding.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved