MTX-5 Aftermarket Steel Clutch Bell for Mugen Seiki - AM-MTX5-T2706 by MUGEN  [AM-MTX5-T2706]

Steel clutch bell designed for MTX-5 compatibility

The Arrowmax AM-MTX5-T2706 clutch bell is supplied as a steel replacement intended to be used on Mugen Seiki MTX-5 RC cars. It serves as the bell housing for the clutch assembly and transfers drive from the motor pinion into the gearbox input shaft while remaining an aftermarket drivetrain part.

The product classification indicates compatibility with the Mugen Seiki MTX-5, but buyers should verify physical fit, including clutch shoe engagement, bell outer diameter, and motor pinion mesh, before committing to final assembly. Ensure there is sufficient clearance inside the bell housing so the bell does not contact the spur gear or gearbox case.

Installation guidance: remove the slipper or clutch assembly per your chassis manual, compare dimensions to the OEM bell, and reinstall using recommended thread locking and correct torque on retaining screws. Test clutch engagement at low throttle and adjust slipper or clutch springs gradually to match track conditions and motor power.

Material notes: the steel construction is intended to deliver consistent engagement characteristics with greater wear resistance relative to softer materials, helping to stabilise clutch bite and reduce premature wear. Inspect after heavy use and replace if you find scoring or deformation.