Mugen MRX5 Lightweight 18mm Turnbuckle Rod - Arrowmax AM-MRX5-H2806  [AM-MRX5-H2806]

18mm titanium linkage for MRX5 tuning

The Arrowmax AM-MRX5-H2806 turn buckle rod is engineered as an aftermarket linkage for the Mugen MRX5 platform, crafted from titanium and specified with an 18mm rod section. It is intended as either a replacement or an upgrade where a compact metal turnbuckle is desired for steering and suspension linkages.

Using the 18mm turnbuckle lets you adjust toe and steering geometry by changing the effective length of the linkage, enabling finer setup steps than fixed-length parts. Titanium keeps weight low and maintains a rigid connection at the joint, which aids consistent steering feel on 1/10 on-road circuits.

Installation follows common RC practices: remove the current turnbuckle, thread the titanium rod into the rod ends or ball cups until roughly centred, then dial in toe and trim steering with small increments. Only use thread-lock on steel mating threads when the vehicle manual recommends it, and confirm rod ends and bearings move freely after fitting.

Package note: Sold as 2 pcs per set matching the product designation in the item name.