Mugen MTC3 Graphite Rear Upright Lever by Factory Pro O-MCP024L [FP-O-MCP024L]

Price:

NZD$15.08

Brand:

Factory Pro

Model:

FP-O-MCP024L

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Precision graphite upright for the Mugen MTC3

The Factory Pro O-MCP024L rear upright lever uses high-grade graphite and is made to match the geometry of the Mugen MTC3. It is a direct approach to enhancing chassis balance and improving responsiveness in corner transitions.

Why graphite is chosen for rear uprights

Graphite combines toughness with low weight, providing resilient support while helping to reduce overall vehicle mass. Installing the Factory Pro O-MCP024L on a Mugen MTC3 can help deliver crisper inputs and steadier exit speed.

Can I use this with aftermarket hubs?

Aftermarket hubs vary in dimensions; check mounting points and clearances. This lever is matched to Mugen MTC3 specs, so compatibility depends on the hub chosen.

Does graphite wear differently than alloy?

Graphite can show surface abrasion but resists permanent deformation. Inspect contact areas regularly and replace if you notice significant wear.

Will this affect suspension tuning?

Yes. Changing mass and stiffness at the rear can alter roll and traction characteristics, so expect to make small setup adjustments after fitting.

Hot Brands