Mugen MTC3 Graphite Upright Lever Factory Pro O-MCP023R Special Edition  [FP-O-MCP023R]

Precision Steering for Your Mugen MTC3

Specifically matched to the Mugen MTC3, the Factory Pro O-MCP023R graphite upright lever provides a stiff, lightweight solution for front-end geometry. This one-piece graphite component is crafted to minimise flex and preserve steering accuracy during close racing.

Advantages of Graphite Components

Graphite offers a favourable weight to stiffness balance, reducing rotating and unsprung mass where it counts. When fitted to the Mugen MTC3, the upright helps the car hold its line through fast corners and reduces unwanted chassis roll under steering loads.

Fit and Practical Advice

Fitting the Factory Pro O-MCP023R is a quick swap using the factory Mugen mounting points. After installation, verify steering endplay and servo horn alignment to ensure consistent response across long runs.