Mugen MTC3 Rear Graphite Upright O-MCP024R by Factory Pro  [FP-O-MCP024R]

Factory Pro Graphite Upright Lever for Mugen MTC3

Fit the Factory Pro Rear Upright Lever O-MCP024R to your Mugen MTC3 to gain a tougher, more stable rear mounting point made from graphite. The design targets hobby drivers seeking a balance of strength and lightness for regular track sessions.

Engineered for Precise Handling

The graphite material keeps weight down while delivering the stiffness needed for accurate suspension response. It is finished to align cleanly with the Mugen MTC3 chassis layout for straightforward installation and consistent handling feedback.

Reasons to Select Graphite

Graphite's favourable strength-to-weight ratio helps preserve traction and steering feel without adding unnecessary mass. That balance supports quicker transitions and better corner control on typical racing surfaces.

Fitting Advice

• Clean mounting holes and contact faces before you fit the upright.
• Run screws in a few turns at a time to ensure even seating.
• Perform an alignment check after installation and after the first outing.