Mugen MTX-5 Tuning Flywheel 7075 HARD - MUGEN AM-MTX-T2702  [AM-MTX-T2702]

Compact aluminium flywheel for MTX-5 tuning

This Arrowmax flywheel serves as a replacement item for Mugen MTX-5 chassis, designed to modify the inertial link between motor and clutch assemblies. The 7075 HARD marking refers to the high-strength aluminium alloy chosen for dimensional consistency under stress.

Using an aluminium flywheel changes engine-mimic inertia on nitro or brushed setups in 1/8 and 1/10 scales, altering how rapidly revs respond during throttle transitions. The part is supplied as a direct spare or hop-up for MTX-series Mugen Seiki vehicles when the part geometry and mounting points match the original flywheel.

Installation guidance: remove the clutch following your chassis manual, swap in this flywheel with the factory fasteners, and confirm there is no interference with the starter or pull-start mechanism before finishing reassembly. Perform stepwise throttle checks after fitting and re-tighten fasteners after initial operation.

This aluminium flywheel is intended for hobbyists focused on chassis tuning and routine maintenance; confirm fitment and test the dynamic effect on a bench or controlled track before competition use.