V One RRR Steering Handle Bar V3R-028 for Kyosho by 3Racing  [V3R-028]

V One RRR Handle Bar Replacement

This handle bar is supplied as a direct replacement for Kyosho V One RRR and V One RRR Evo steering link locations, intended to recover correct tie-rod alignment and predictable steering behaviour without changing the chassis layout.

Role and fitment: the part mounts where the original handle bar or steering link sits, helping to maintain steering centring and response on competitive on-road setups. Consider it a service or setup component rather than an isolated power upgrade.

Installation guidance: remove the original handle bar, check link lengths and pivot positions, install the replacement and verify smooth steering travel across full lock. Look for any binding and adjust toe and centring as needed. Use the existing fixing points and inspect link ball seats and bearings during the swap.

Tuning notes: whenever the handle bar is replaced as part of setup changes, re-evaluate front-end geometry and steering throw. Minor link length changes will affect turn-in and mid-corner balance, so make measured adjustments and test incrementally.