O.S. Engine OS49415010 Service Gasket Kit for GF40  [OS49415010]

O.S. ENGINES CARBURETOR GASKET SET GF40
Price:
NZD$11.48
Brand:
O.S. Engine
Model:
OS49415010
GTIN:
4531028153851
Condition:
Brand New
Write a review

Replacement Gaskets for GF40 Carburetor

This O.S. Engine OS49415010 gasket pack contains spare sealing parts specifically for GF40-model RC carburetors. The components are intended to reestablish correct seals around the carb body and throttle linkages to maintain consistent fuel and air metering after service.

Compatibility: identified for GF40 carburetor models. Fitting is simple for those experienced with small nitro or glow RC engines: detach the carburetor from the engine, disassemble the carb body carefully, strip out old gasket remnants, clean the mating faces with a recommended solvent, then fit the new gaskets and reassemble. Ensure screws are tightened evenly and confirm smooth throttle operation before running.

Tuning effect: sealed gaskets prevent air leaks that cause idle instability and unpredictable needle adjustments. Swapping out collapsed or damaged gaskets is a standard troubleshooting and upkeep action when inconsistent running or flange leaks occur.

How do I install the new gaskets step by step?

Remove the carb from the engine, open the carb body, clean all surfaces of old material and residue, position each gasket in its flange or groove, then reassemble, tightening fasteners evenly. Verify smooth throttle movement before test running.

Must the carburetor be removed to change these gaskets?

For best access and to avoid damage, remove the carburetor from the engine when replacing gaskets so you can clean and seat new seals properly.

What cleaners are safe when preparing surfaces?

Use a mild solvent or isopropyl alcohol intended for model maintenance to remove old gasket material and fuel residue; avoid aggressive chemicals that can damage soft components.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved