This turbo glow plug serves as an ignition element for RC nitro engines. The P4 Super Hot classification identifies a hotter filament that shortens warm-up time and can stabilise idle while trimming and tuning.
Compatibility note: the plug is produced for nitro R/C engines and is not for electric setups. Always confirm thread specifications and recommended heat range with your engine documentation before replacing the plug.
Fitting advice: allow the engine to cool before removal, start the new plug by hand until the threads seat, then tighten carefully with the appropriate wrench. Avoid over-torquing. Run a controlled break-in and re-check tightness once the engine is at normal operating temperature.
Tuning guidance: a super-hot filament promotes quicker ignition and can affect idle. When changing needles or compression, proceed incrementally and use exhaust color and throttle response as your primary feedback; consult experienced hobbyists if unsure.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
