Outlaw Rampage PRO 2.0 Front Lower Arm V2 Replacement - Kyosho OL046  [KY-OL046]

Kyosho OL046 - Front Suspension Arm V2
Price:
NZD$0.00
Brand:
Kyosho
Model:
KY-OL046
GTIN:
4548565522279
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Front Arm V2 — Durable Fitment

The Kyosho OL046 front suspension arm V2 serves as a replacement component for the Outlaw Rampage PRO 2.0 chassis. It is intended to replace a worn lower arm and restore the suspension geometry that governs steering characteristics and tyre wear.

Functionally the arm locates the wheel hub and resists forces that affect camber and toe while driving. The V2 revision reflects updates to match factory dimensions and ensure correct fitment without needing alterations to the chassis.

Installation notes: remove the front wheel and existing lower-arm mounting hardware, carry over any bushings or pins from the old arm where applicable, fit the OL046 with the same orientation, and tighten fasteners to the chassis manufacturer's specifications. After installation, inspect wheel alignment and suspension motion to confirm correct behaviour.

Tuning impact: replacing one arm can correct imbalanced steering inputs or uneven tyre wear; installing a matched pair is the best practice to keep geometry consistent when adjusting camber, toe, or roll centre during setup.

Models Compatible

  • Outlaw Rampage PRO 2.0
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Does this V2 arm match factory geometry exactly?

The OL046 V2 is engineered to align with factory geometry for the Outlaw Rampage PRO 2.0, so fitment and mounting points should correspond to the original design.

Are there material or strength improvements in V2?

The V2 designation focuses on revision and fit; users report consistent fit and reliable service when installed and checked to recommended torque values.

Will I need replacement pins or bushings?

In most cases you can transfer existing bushings and pins from the original arm. Inspect these items for wear and replace as needed for secure mounting.

How should I verify durability after fitting?

Run a short test session and then recheck fastener torque, alignment, and any signs of play at the ball joints or pivot points to ensure the arm is performing as expected.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved