Pair of Hirobo HI2506026 Flat Washers 14 x 18.5 x 0.5T for helicopter general parts  [HI2506026]

Precision flat shim for helicopter components

The Hirobo flat washer HI2506026 is crafted as a thin shim for RC helicopter general parts where exact spacing is required. Supplied in a two-piece set, they help keep consistent clearances and simplify reassembly after servicing.

Durability note: these washers provide a thin, repeatable separation that can reduce wear between mating parts and help maintain alignment under routine use. The specified size (14 x 18.5 x 0.5T) indicates the inner diameter, outer diameter and the thin profile intended for fine adjustments rather than structural load bearing.

Service advice: slide the washer onto the fixing shaft until it seats, ensure components sit true, and apply torque as recommended for the part. If using several shims together, verify the combined thickness to prevent excess preload or altered linkage geometry.