Precision 27mm Titanium Turnbuckles for 1/10 - Yokomo YOKZCTB27  [YOKZCTB27]

Precision 27mm titanium turnbuckles

These 27mm titanium turnbuckles come as a matched pair to serve as adjustable tie-rod links for steering and suspension on 1/10 scale RC vehicles. Sold as two pieces, they let you fine-tune linkage length between ball ends and rod ends to adjust toe settings, correct small geometry deviations, and refine steering response without replacing rigid rods.

Fitting advice: for hobbyists familiar with turnbuckles, remove the existing link and note left- and right-hand threads, then thread in to the nominal length and make small, equal adjustments at both ends. Secure any locking hardware you currently use and verify unobstructed movement through the steering knuckles and suspension pickup points prior to running.

Setup tips: use incremental length changes to set minor toe-in or toe-out, correct slight asymmetry, or adjust steering centering. Titanium reduces outer-link weight and resists rust, helping maintain consistent geometry. Check ball cups and mating components for wear and compatibility and recheck after the first session.