PROTOform 1720-01 PRO-TC 200mm Track Wing  [PRF-1720-01]

PROTOform 1720-01 PRO-TC Wing Kit 200mm
Price:
NZD$23.78
Brand:
PROTOform
Model:
PRF-1720-01
Condition:
Brand New
Write a review

PRO-TC Wing Kit for 200mm Bodies by PROTOform 1720-01

The PROTOform 1720-01 PRO-TC Wing Kit is made for 200mm on-road models and focuses on practical gains in stability. It gives club drivers a low-effort option to sharpen rear traction and maintain control at speed.

Key Advantages for Club and Weekend Racers

Designed to match a wide range of 200mm bodies, the wing improves aerodynamic balance without heavy modifications. All mounting pieces are included so you can fit it and head straight to testing.

Simple Setup Steps

Start with the manufacturer suggested mounting height and angle, then tweak as needed. Small changes to ride height or wing tilt will show clear effects on corner exit and mid-corner balance.

Will the PROTOform 1720-01 PRO-TC work with lexan and polycarbonate shells?

Yes, it is compatible with most lexan and polycarbonate 200mm shells, though some trimming of the spoiler area may be useful for a flush fit.

Can I tune the wing for different track surfaces?

Absolutely. A higher angle gives more downforce on slippery surfaces while a lower angle suits high-grip asphalt; test to find the balance.

Is extra reinforcement needed for high-speed runs?

For most hobby use the supplied hardware is fine, but racers running at very high speed or heavy impacts may add small reinforcement blocks under mounting points.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved