R12 Roll Spring Holder R12-21 for Yokomo R12 Chassis  [R12-21]

This aluminium roll spring holder has been produced to suit the Yokomo R12 platform as a scale RC part. It holds the roll spring securely and gives defined mounting points so you can repeat tuning changes with confidence.

Inside the box are two sets, matching the pair configuration commonly fitted on R12 touring suspensions. Use them to ensure consistent spring location and a low mass fixing for roll spring adjustments during testing or events.

Installation note: the piece is intended for direct fitment to the supported R12 chassis variants listed below, and its tuning function is to alter roll spring position and therefore affect roll stiffness and transient behaviour rather than alter primary suspension geometry.

Contents included

• Roll spring holder - 2 sets

Compatible chassis

• YR-R12C3
• YR-R12C31