RADTEC RAD-AC-10020 2.01mm Titanium Coated Hand Reamer - Hobby Edition  [RAD-AC-10020]

RAD-AC-10020 Diameter 2.01mm Titanium Coated Hand Reamer
Price:
NZD$43.07
Brand:
RADTEC
Model:
RAD-AC-10020
Condition:
Brand New
Write a review

Hand Reamer for RC Tuning

The RADTEC RAD-AC-10020 is a hand reamer sized at 2.01mm for exact reaming tasks on model parts. Its titanium finish helps retain edge life while allowing fine control when adjusting fitments and clearances.

Why Use Titanium on a Reamer?

Titanium coating gives extra abrasion resistance and smoother cuts, which is useful when you ream multiple parts during setup. That longer edge retention reduces the need to replace tools frequently.

Where This Tool Fits in Model Setup

Targeted at 1/10 scale RC work, the reamer is suited to refining pin holes, aligning suspension mounts, and easing tight plastic assemblies without enlarging holes excessively.

Will the RADTEC reamer work on carbon fibre parts?

Carbon fibre can fray and is abrasive; proceed with caution. Use light passes and consider a specialist cutter for clean finishes on carbon components.

What technique gives the best hole finish?

Rotate the reamer slowly by hand and remove small amounts with each pass. Back out frequently to clear swarf and keep the hole round.

Can I resharpen a titanium coated reamer?

Resharpening is possible but will remove the coating over time. When edge life drops, consider replacing rather than repeatedly stripping the finish.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved