RAD-AC-20006 RADTEC Precision Chassis Droop Gauge for Pancar  [RAD-AC-20006]

RAD-AC-20006 Ultra-Fine Chassis Droop Gauge (-2.6-0mm) for Pancar
Price:
NZD$22.28
Brand:
RADTEC
Model:
RAD-AC-20006
Condition:
Brand New
Write a review

Accurate droop checking for Pancar setups

Modelers and club racers will find the RADTEC RAD-AC-20006 Ultra-Fine Chassis Droop Gauge a practical tool for verifying suspension droop on Pancar cars. Its fine gradations cover the -2.6mm to 0mm window so you can standardise your setup between runs.

Practical, repeatable measurement

Made with Pancar geometry in mind, this gauge delivers consistent readings that help you maintain predictable handling. The fine scale is useful when making conservative, repeatable changes to balance and feel.

Setup tips for better traction

Use the RADTEC gauge during initial setup and when testing tyre compounds or ride heights. Adjusting droop by small amounts can influence how the car transfers weight and how it grips through corners.

Will the tool fit older Pancar layouts?

The RADTEC RAD-AC-20006 is aimed at modern Pancar measurements, but it may be compatible with older layouts if the mounting points line up. Verify measurement points before use.

How often should I check droop?

Check droop whenever you change springs, dampers, ride height or tyres, and after travel or crashes. Regular checks keep handling consistent from practice to finals.

Can this gauge speed up setup sessions?

Yes. Using an accurate gauge like the RADTEC RAD-AC-20006 reduces guesswork, letting you document settings and compare results faster between test runs.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved