RADTEC RAD-MA-10005 110mm Flat Bonded Flex Sensor Leads  [RAD-MA-10005]

RAD-MA-10005 110mm FLAT BONDED Flex Sensor Wires
Price:
NZD$5.51
Brand:
RADTEC
Model:
RAD-MA-10005
Condition:
Brand New
Write a review

Low Profile Sensor Wiring by RADTEC RAD-MA-10005

For builders wanting neat, dependable wiring between brushless motors and ESCs, the RADTEC RAD-MA-10005 110mm flat bonded flex sensor wires are a practical pick. Their flattened construction keeps the sensor cable compact and easy to secure inside the chassis.

Optimised for Sensored Brushless Units

The RAD-MA-10005 is aimed at sensored brushless systems where stable signal lines matter. The flat bonded design helps limit movement and keeps connections steady during spirited driving or rough terrain.

Practical Fitment for Tight Builds

These cables suit frequent component swaps with a simple plug approach and a 110mm span that fits most standard models without leaving excessive cable length to manage.

Are these wires suitable for compact model builds?

Yes, the flat profile and 110mm length are chosen to suit tighter installations where regular round cables may be bulky or difficult to route.

Do I need special connectors to use them?

They use standard sensor wiring terminations compatible with most ESC and motor sensor ports, though you should double check pin alignment before connecting.

How should I route the cables to avoid interference?

Keep the sensor wires separated from high current motor leads and secure them along chassis edges or with small clips to prevent movement that can introduce noise.

What maintenance helps extend their life?

Inspect the bonding and connector ends periodically, avoid sharp bends, and replace any cable that shows fraying or exposed conductors to maintain reliable signalling.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved