RADTEC PDJ-10007 T4 50mm Steel Double Joint Dogbone - Race Ready Component  [RAD-PDJ-10007]

RAD-PDJ-10007 T4 50mm PREMIUM Steel Double Joint Dogbone, 1 pcs
Price:
NZD$13.77
Brand:
RADTEC
Model:
RAD-PDJ-10007
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - RADTEC - Double Joint Parts category
Write a review

Built for T4 Drivetrains

The RADTEC PDJ-10007 T4 50mm Steel Double Joint Dogbone is crafted to match the T4 chassis geometry. Manufactured from resilient steel, it resists deformation under load and helps maintain consistent handling during laps. This part is a solid choice for hobbyists tuning their car for competitive club racing.

What skill level is needed to fit this dogbone?

Basic disassembly of the rear diff and a few common tools are all you need to replace the dogbone; no advanced setup required.

Which lubricant should I use on the joints?

A light grease formulated for metal drives or a thin oil designed for steel-on-steel contact will reduce wear and noise without attracting excess dirt.

Is the 50mm length standard for T4 setups?

The 50mm length matches common T4 rear drive dimensions, providing correct clearance and joint angle for typical race layouts.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved