Radtec RAD-BEL-10002 White Low Friction Belt S3M510 for Serpent 4X  [RAD-BEL-10002]

RAD-BEL-10002 Radtec Low Friction White Front Drive Belt (S3M510) for Stock (Serpent 4X)
Price:
NZD$23.86
Brand:
RADTEC
Model:
RAD-BEL-10002
Condition:
Brand New
Write a review

Reduce Drivetrain Drag on Your Serpent 4X

Radtec RAD-BEL-10002 is a low friction white front drive belt (S3M510) built to enhance drivetrain smoothness in Serpent 4X stock configurations. The reduced surface resistance helps the car accelerate and respond more predictably.

Benefits for Stock Racing

By minimising internal resistance, this Radtec belt supports steadier power delivery and better belt tracking. It is a practical upgrade for drivers chasing consistent handling across runs.

Quick Swap Installation

The belt installs into the Serpent 4X routing without special tools or chassis changes. Its snug fit keeps belt tension stable under race conditions.

Will this belt improve lap consistency?

Yes, reducing drivetrain friction helps smooth out power pulses and can lead to more repeatable lap times when combined with a balanced setup.

Does it need special cleaning products?

No special products are required. Remove grit and light residue with a soft brush and isopropyl if needed, avoiding harsh solvents.

Is it the same pitch as the stock belt?

The belt uses the S3M profile listed with the product. Verify compatibility with any aftermarket pulleys before installation.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved