Radtec RAD-BEL-10005 S3M351 White Front Drive Belt for A800 Stock  [RAD-BEL-10005]

RAD-BEL-10005 Radtec Low Friction White Front Drive Belt (S3M351) for Stock (A800)
Price:
NZD$27.95
Brand:
RADTEC
Model:
RAD-BEL-10005
Condition:
Brand New
Write a review

Upgrade A800 Stock Drivetrain with the Radtec RAD-BEL-10005

The Radtec low friction white front drive belt S3M351 is tailored for the A800 Stock to lower resistance and promote steadier power delivery. Its design focuses on dependable service life while trimming drivetrain losses.

Why Choose the Radtec Drive Belt

Engineered to match A800 Stock pulley geometry, the Radtec belt helps reduce heat and slippage under load. The white colour aids quick visual checks between practice sessions, while the S3M351 profile ensures alignment with stock components.

Fitment Notes and Care

Ensure pulleys are free of grit and that bearings spin freely before installing the Radtec RAD-BEL-10005. Correct belt alignment and moderate tension will deliver the best balance of efficiency and component longevity. Inspect for glazing or tooth wear after track use.

Can I use this belt on upgraded pulleys?

If the upgraded pulleys retain the S3M tooth profile and match the belt width of the A800 Stock layout, the Radtec RAD-BEL-10005 should be compatible. Double-check tooth count and spacing first.

How often should I replace the belt?

Replacement interval depends on use; inspect the belt every few track sessions and swap it at first signs of wear or loss of engagement to keep driveline parts safe.

Is there any break-in procedure?

Run a few short, moderate-power sessions and then recheck tension and pulley alignment. New belts tend to seat slightly, so a quick re-tension after initial runs is recommended.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved