Radtec RAD-BEL-20001 White Low Friction Rear Belt S3M180 Suitable for BD8 34T and MTC1  [RAD-BEL-20001]

RAD-BEL-20001 Radtec Low Friction White Rear Drive Belt (S3M180) for Stock (BD8*34T/MTC1)
Price:
NZD$19.60
Brand:
RADTEC
Model:
RAD-BEL-20001
Condition:
Brand New
Write a review

Keep Power Clean with Radtec RAD-BEL-20001

The Radtec RAD-BEL-20001 Low Friction White Rear Drive Belt (S3M180) gives club drivers a reliable option to keep drivetrain losses low in stock cars such as the BD8*34T and MTC1. The belt is formulated to slide smoothly on pulleys, helping maintain consistent performance.

Performance Benefits for 1/10 Track Cars

Specifically matched to 1/10 on-road setups, this belt reduces wasted energy and lowers operating heat. Reduced friction means less frequent replacement and steadier lap times during practice or competition.

Where It Fits and How to Swap It

Designed to fit common chassis including the BD8*34T and MTC1, replacing a worn belt is a quick service job. Correct alignment and tension are the key steps to getting the best life out of the Radtec RAD-BEL-20001.

Is the S3M180 profile standard across brands?

S3M is a common tooth profile, but belt length and tooth count must match your pulleys for a correct fit.

Will this belt change gearing feel?

It does not alter gear ratios, but by reducing resistance it can make throttle response feel a bit cleaner under load.

Should I lubricate the belt?

Radtec belts are low friction by design and do not require lubrication; contaminants should be kept away and periodic cleaning is enough.

How do I know when to replace the belt?

Replace if you see glazing, fraying, missing teeth, or stretched fit that affects tension and alignment.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved