RADTEC RAD-MA-10004 90mm Flat Bonded Flex Sensor Wires Neat Lead Pack  [RAD-MA-10004]

RAD-MA-10004 90mm FLAT BONDED Flex Sensor Wires
Price:
NZD$5.45
Brand:
RADTEC
Model:
RAD-MA-10004
Condition:
Brand New
Write a review

Compact sensor leads for neat installations

Model RADTEC RAD-MA-10004 90mm Flat Bonded Flex Sensor Wires are aimed at hobbyists who prioritise clean wiring runs. Their low-profile shape is useful for routing between motor housings and ESCs without bulk or clutter.

Flexible and easy to route

The flexibility of these sensor wires makes them straightforward to manoeuvre in narrow spaces and around mounting tabs. The bonded flat construction holds the conductors together for tidy placement and less movement under vibration.

Suited to a range of RC models

Whether youre upgrading a racer or tuning a crawler, these flat sensor leads help keep sensor signals consistent for better motor response. The layout reduces cable bulk and helps prevent signal disruption from nearby components.

Will these wires fit my ESC and motor pair?

They fit most standard sensor ports used on brushless motors and ESCs. Confirm the connector pinout and spacing for your specific parts before installing.

Can I shorten the RAD-MA-10004 wires if needed?

Yes, you can trim and re-terminate these wires, but use proper soldering technique and insulation to avoid signal issues. Keep the wires as short as practical for the best results.

Are these wires suitable for high-vibration builds?

The bonded flat design helps limit movement, but always secure the leads close to their connectors and away from suspension links or driveshafts to reduce wear.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved